Arduino – Draik's Projects

Keepsake: Finished Product

After the project has been 3D printed, the components placed and connected, it was time to power it up, and make sure it works, before sealing it shut.

Category: 3D Printing, Arduino, Personal Keepsake, Project | LEAVE A COMMENT

October 2

With everything connected, it’s time to test the code that will load the pictures on the microSD, and display them on the 2.8″ TFT display. If any issues arise, I’ll be able to trace everything with ease, and can use the Arduino IDE to view the Serial Monitor for errors.

Category: Arduino, Personal Keepsake, Project | LEAVE A COMMENT

October 1

Keepsake: Wiring

Once the components are fitted into the toolbox and frame, wires can be measured to ensure a clean fit. The wires should not be tight, nor should there be too much slack that cables are coiled into a corner.

Category: Arduino, Personal Keepsake, Project | LEAVE A COMMENT

September 30

Keepsake: Parts

There isn’t much going into the project, and I’ve miniaturized it where possible. Mainly, instead of using an Arduino Uno, I’ll use the Arduino Pro Mini microcontroller. While not entirely necessary, I’m adding a buck converter between the power source and the microcontroller.

Category: Arduino, Personal Keepsake | LEAVE A COMMENT

September 29

Motorcycle Picture Frame: Finished Product

The motorcycle picture frame is finally complete. The project was centered around the electronics, and designed with our motorcycles in mind. The stage is set, and pictures are cycling through the TFT display.

Category: Arduino, Motorcycle Picture Frame, Project | LEAVE A COMMENT

Keepsake: Finished Product

Keepsake: Programming

Keepsake: Wiring

Keepsake: Parts

Motorcycle Picture Frame: Finished Product