ILI9341 – Draik's Projects

Keepsake: Finished Product

After the project has been 3D printed, the components placed and connected, it was time to power it up, and make sure it works, before sealing it shut.

Category: 3D Printing, Arduino, Personal Keepsake, Project | LEAVE A COMMENT

October 1

Once the components are fitted into the toolbox and frame, wires can be measured to ensure a clean fit. The wires should not be tight, nor should there be too much slack that cables are coiled into a corner.

Category: Arduino, Personal Keepsake, Project | LEAVE A COMMENT

September 30

Keepsake: Parts

There isn’t much going into the project, and I’ve miniaturized it where possible. Mainly, instead of using an Arduino Uno, I’ll use the Arduino Pro Mini microcontroller. While not entirely necessary, I’m adding a buck converter between the power source and the microcontroller.

Category: Arduino, Personal Keepsake | LEAVE A COMMENT

September 28

Motorcycle Picture Frame: Design

Having the electronics laid out on paper, I can better determine placement for the overall design. Running cables throughout the project can be hidden inside objects, such as pillars, bleachers, platforms, stands, etc. Measure multiple times, and print once.

Category: Arduino, Motorcycle Picture Frame | LEAVE A COMMENT

September 28

Motorcycle Picture Frame: Parts

The parts used in this project were taken from the attempt at the incorporating electronics into the jewelry box armoire project. Without recreating the blog posts, I’ll condense the information for what was used, along with any changes to the overall project.

Category: Arduino, Motorcycle Picture Frame, Project | LEAVE A COMMENT

Keepsake: Finished Product

Keepsake: Wiring

Keepsake: Parts

Motorcycle Picture Frame: Design

Motorcycle Picture Frame: Parts